Queensland security OSD High Speed Dome Camera Installation Manual download pdf (Page 12)

Installation Guide

3. Dome Setups and Cable Connection

Before installing or connecting the dome camera, please refer to this section

and complete preparation, switch setting and communication switch settings.

3.1 Preparations for Indoor Dome Camera Setups

Follow the steps below to remove the PE cushion inside the dome cover and

take off the lens cap to prepare for subsequent switch setting.

Step 1: Unpack the dome package

and take out the dome body.

Step 2: Unscrew the three screws on

the dome back, as marked in the

figure, and remove the dome

housing with the dome cover.

Step 3: Remove the PE cloth sheet

and take off the lens cap.

Step 4: Replace the dome housing

with the cover back. Then screw it

and the dome back together.

When replacing the dome

housing back, please align

the cooling fan with the vent on the

dome housing.

Step 5: Set the switches located on

the bottom of the dome body. Refer

to section 3.3 Dome Setups for

detailed information about various

switch setting.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 57 58

No comments

Queensland security OSD High Speed Dome Camera Installation Manual Page 12